LSBX | Rosetta-I

Model

Watt

Lumens

Voltage

CCT

LPW

Replaces

LSBX150

150W

19,000LM

100-277V

4000K

5000K

126LM/W

400W MH

LSBX300

300W

38,200LM

125LM/W

1000W MH

Type III

Type III optics produces an asymmetrical pattern that directs the majority of the light forward and equally on both sides of the luminaire.  In a back-to-back configuration, it creates a rectangular pattern which can extend pole spacings.

Type IV

Type IV is suitable for applications where light is primarily required to forward with minimal backlight. Typical installations include perimeter poles

Type V

Type V optics produce a symmetrical square distribution pattern that distributes light equally on all sides of the luminaire. Type V luminaries provides utility for most area lighting applications.

 PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION

• Please read the product specification carefully first to confirm that the working environment is in line with the condition on the specification before it is used. 
• Please confirm the input voltage and frequency before use. 
• The light must be installed by professional personnel 
• If the power cord and case of the products are damaged, it will be regarded as disqualified product and should not be used. 
• If external soft cable or wire of the product is damaged, the wire should be replaced by manufacturer or service agent or personnel with similar qualification to avoid danger.

• This luminaire is designed to operate in ambient temperatures ranging from -40°F to 150°F and to be horizontally mounted facing down.
• This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
• This product is not available for several special environments, such as places with corrosive gas liquids or high pressure water vapor. 
• CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR
• CAUTION - RISK OF FIRE

Square/Round Pole (Figure 1)

Slip-Fitter (Figure 2)

Wall-Mount (Figure 3)

Figure 1

Figure 2

Figure 3

• Remove the side plate from mounting bracket. Please skip to step 3 if mounted onto the square Pole. 
• Attach round pole mounting plate on mounting bracket.
• Route the cord into mounting bracket through the hole for wiring, slide the fixture onto the bracket and tighten 2 bottom screws.
• Slightly drag the wires to make sure the hole on bracket is sealed by silicon gasket.
• Make wiring connection as per wire diagram below, replace the side plate and fasten screws. 

• Connect the wires to L/N/GND
• Remove the cover and adjust the bracket to the desired angle
• Install the bracket on the pole and fix it with screws

• Remove the side plate by loosen the screws.
• Fix the back plate onto the arm bracket with screws provided.
• Use the metal template provided to locate footprint on the wall to drill the holes, then fix the bracket on the wall with screws.
• Route the power cord into wall mount bracket, slide the fixture onto the mounting bracket, then tighten bottom screws.
• Make wiring connection inside of bracket and replace the side plate with screws.